- Cam Timing and EFI
- Why do carbs seem to do better than EFI for MPGS on 300s?
- surprising spark plug find
- code 10
- Am I supposed to use a drain plug gasket?
- My SIX is not so smooth :(
- Hesitation, stumble and bogs upon acceleration. Hard start once its warmed. I have codes. Pls Help!
- A manual clutch question
- 4.9 300 1992 coil wires please help
- sputter hot start
- High idle then stall
- It's about roller rockers..Comp Cam
- Camshaft timing?
- Carb Fuel Inlet Replacement?
- rebuild it or...
- 1994 4.9L Cold Air Intake
- 5-speed Questions
- Video of a fresh 300 rebuild, trail and errors haha
- Heater valve/ hose question
- Looking for some advice trying to tune a split port offy set up
- Attention: F-250 restorer
- 1991 F150 4.9L Serious issues
- Int/Exhaust manifold is a PITA!
- Remodeler
- Crower 19210 Cam
- 85 300 running rough (marine install)
- Need help diagnosing loss of power
- PCV :"To be, or NOT to be"
- HELP!!!!! Solving a "miss" when most all is new
- Carb.....whats it worth???