6.9l customization
Thread Starter
|
Elder User
Joined: Aug 2007
Posts: 589
Likes: 2
From: Nutter Fort,West Virginia
has anyone made a oil separator to replace the pcv valve?
i am thinking about making one setup so that there is a drain for the oil back into the crankcase. but i would like to know if there are any good designs floating around.
i am thinking about making one setup so that there is a drain for the oil back into the crankcase. but i would like to know if there are any good designs floating around.
Thread Starter
|
Elder User
Joined: Aug 2007
Posts: 589
Likes: 2
From: Nutter Fort,West Virginia
How to put a 6 speed ZF in a 2wd IDI - Diesel Forum - TheDieselStop.com
does anyone know how the bracket he made looks? i can't figure out how he made the bracket for upper two bolts without milling off part of the block
does anyone know how the bracket he made looks? i can't figure out how he made the bracket for upper two bolts without milling off part of the block
Thread
Thread Starter
Forum
Replies
Last Post
lovemy150's
1999 - 2003 7.3L Power Stroke Diesel
6
Sep 21, 2006 12:05 PM
Pigeon
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
4
Apr 29, 2005 04:35 PM
