No, but the App did.

I didn't do anything different, but the following day after posting this complaint, it worked normally. I have had no more problems with it connecting and disconnecting to Torque. (I had at some point while troubleshooting, changed a number of different Torque App settings and returned some to default.)

But I did notice a different bluetooth app having problems. It could be my phone and related to the particular Bluetooth on my phone. It is a Droid RAZR M. The other bluetooth app seems to think it is disconnected when it really is connected according to the settings page and the bluetooth device.

 

Is there an actual fuel pressure pid that works?

 

No. The 7.3L doesn't have any fuel pressure data in the PCM, so no PID. There is no factory fuel pressure sensor on the truck.

 

I meant for the 6.0 sorry..

 

Does anyone have the equation info for the delta pid?

 

Post 130........

 

Delta Temp
Deltas
Min Value: 0.0
Max Value: 30.0
Scales Factor: X1
Unit Type: Del F
Equation([221310]*1.8)+32)-(([05]*1.8)+32

 

Does anyone have a PID for FICM Sync? I can't find one any where and I'd like to be able to monitor it.

 

 

Is 0 for yes being sync or is 1 for yes?

 

0 is for no sync, 1 for sync

 

For us V10 gasers has anyone ever tested adding cylinders #9 and #10 to the Ford PIDs, Torque Pro App? I have looked all over FTE and the Torque Website without any success. Just wondering before I attempt to write them?

Any thoughts, really worried about #10 adding another space and decimal place?

CYL #9 Cumulative Misfires
221616
9CM
0.0
100.
X1
MISFIRES
((A*256)+B)

CYL #10 Cumulative Misfires
221617
10CM
0.0
100.
X1
MISFIRES
((A*256)+B)

 

Did you ever get this figured out? I have been trying to get these also.

 

No, my calculation was flawed, 221617 was already used by the system. I contacted Ford engineers and didn't get a response. I will ask my mechanic next time I meet with him for my plugs and coils change out.

 

Hi Folks,

I'm looking for the full set if pids I can get for a 1999 Ford F-250 Super Duty 6.8ltr gas engine to use in Torque Pro.

Would anyone please post these as a DL for me? Export? Attachment? I've used them before on other vehicles as a .xls spreadsheet etc, but I just can't find what I want for this engine.

Thanks in advance.