A shot of the shop showing the front diff up on the work stands with my ‘custom’ cut 2×4 :), cut with the diameter of the axle tube housing to better secure it on the stands when working. Can also see rear diff partially assembled on ground. A shot of the table after […] More »
By: admin | June 17, 2002
By Erik Marquez Here you will find a short write up on a relay system I built for my 78 Bronco. I found that I had 11.5 volts at the head lights before I built and installed this system, after installation, I now have full alternator output, or up to 14.6 volts. While this may […] More »
By: admin | April 5, 2002
Originally posted in 1999 by Ken Haley This article was originally posted in the Big Ford pickup/Bronco list in response to an energetic first time engine builder. Organization is the key to a successful rebuild. This article gives some ideas for organizing your work. A bit of advice for those without years of experience pulling […] More »
By: Nolan Browning | July 19, 1999
Copyright © 1997 Kenneth Payne, All International Rights Reserved. This document may not be copied or published without prior written consent of the author. Note: If you have only a passing familiarity with automotive repair, it is recommended that you do not attempt this procedure. This procedure involves disassembly of the braking system […] More »
By: Nolan Browning | July 19, 1997
Source: Ford Motor Company Ford Awarded Prestigious Golden Calipers From Tough Field of Seven (NEW YORK, NY – December 17, 2003) – MOTOR TREND magazine, the world’s #1 automotive authority and part of the PRIMEDIA Consumer Automotive Group, today announced the selection of the Ford F-150 as the 2004 Truck of the Year. Each year […] More »
By: admin | December 31, 1969
You must be logged in to post a comment.