When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I haven't done anything to it since I just picked it up yesterday and it pretty much sapped my wallet for the next 2 weeks, but I did get some photos for everyone. Here are some of my favorites. The rest are in my album.
Dad did this yesterday, while I was away... (what a nice suprise when i went to work on it before work today (then it started raining almost immediatly)
(you can also see where we WaterBlasted the cab in these pics)
A before, for the heck of it...
Pulled out the glovebox to get to the dash pad nuts. The two on the passenger side, no problem. The one over the glovebox, no problem. The two in the center, well the one lower down was fine but I'll be damned if I can find the other center one. Tomorrow I pull the dash pod and see if the last four give in. This week-end the dash from Connor gets installed .
didn't get much of anything done today, a few bolts taken loose, and that's about it...
after I go to bed, and get back up today, the interior comes out, and goes into the back of the bronco for safekeeping, and then the front clip starts going back together...
I worked on the brakes. I have to replace all the lines going from the proprotioning valve back. Better now then when I'm going down the road and it blows.
didn't get much of anything done today, a few bolts taken loose, and that's about it...
after I go to bed, and get back up today, the interior comes out, and goes into the back of the bronco for safekeeping, and then the front clip starts going back together...
Got started on this, and now i've been called into work