Something Gone Wrong
Thread Starter
|
Hotshot
Joined: Feb 2007
Posts: 10,499
Likes: 10
From: Sterling Heights,Mi
Decorations...
Yes I did the harpoon as well, Did her both, If the compression fitting wasnt tight, I would have had problems at a 1/4 tank, not at a full tank, wouldnt I???
Yes I did the harpoon as well, Did her both, If the compression fitting wasnt tight, I would have had problems at a 1/4 tank, not at a full tank, wouldnt I???
Logistics Pro
Joined: Nov 2006
Posts: 3,685
Likes: 374
From: Fallon,NV & Bainbridge OH
Hope it turns out good as it is a pain to re-do what you just did. I just did mine about two weeks ago and so far so good. Look at the bright side I would rather be doing it at 80 and 88% than 20 and 30%.
Thread Starter
|
Hotshot
Joined: Feb 2007
Posts: 10,499
Likes: 10
From: Sterling Heights,Mi
Gas tank on the ground, big ol retainer nut loose, going our with rags to (again) make sure everything is clean, then pulling the pick up.. I am taking pictures this time.
FTE Stories
Ford Trucks for Ford Truck Enthusiasts
Top 6 Best Deals Available on New Fords & Lincolns Right Now
Brett Foote
This Hennessey Takes the Expedition Tremor's Off-Roading Capability to the Next Level
Verdad Gallardo
Top 10 Fords at 2026 Carlisle Ford Nationals
Joe Kucinski
3 Best / 3 Worst Parts of Modern Ford Ownership
Brett Foote
10 Amazing Upgrades That Solve Common Ford Truck Owner Headaches
Pouria Savadkouei
Every 2026 Ford Engine Explained
Brett Foote
10 Ugly Ford Trucks That We Still Kinda Love
Joe Kucinski
10 Things Every Truck Owner NEEDS (2026 Edition)
Michael S. Palmer
Rezvani's Latest Post-Apocalyptic Monster Is a Ford F-150 Raptor Underneath
Verdad Gallardo
Thread Starter
|
Hotshot
Joined: Feb 2007
Posts: 10,499
Likes: 10
From: Sterling Heights,Mi
I have just aken off about 1/2"
Sorry Chris, I didnt slow down enough to look.
Just ran the pump, while on the ground, after 3 runs ( air out ) sounds good, getting ready to raise it..
Sorry Chris, I didnt slow down enough to look.
Just ran the pump, while on the ground, after 3 runs ( air out ) sounds good, getting ready to raise it..
Lead Driver
Joined: Jan 2007
Posts: 6,708
Likes: 5
From: Kiowa CO
Well, I haven't done the in-tank mods on my truck but I did run into a similar problem with an older vehicle where I had a fuel starvation problem after replacing a fuel sender/pump assembly in the tank. I fought it for days. what happen in my case is when the tank and all the stuff was on the ground - it worked perfectly, when I raised the tank and secured it to the frame, the supply fuel line in the tank would drop down enough during the raising process and would cause my starvation issue. Just a random guess that you may have something like that going on.
Posting Guru
Joined: Dec 2007
Posts: 2,290
Likes: 2
From: SEMO
I think Pop has your answer.^^^
