0.080 overbore on a stroker
Thread Starter
|
Senior User
Joined: Dec 2000
Posts: 296
Likes: 0
From: Carson USA
0.080 overbore on a stroker
My D1VE block is already bored .030 over.... Would it be too much to bore it to .080 over? I was looking at JE Pistons and it looks like they don't have .060 over as a standard option. Thanks
Adam
Adam
Senior User
Joined: Sep 2003
Posts: 262
Likes: 0
Call JE. Will it go .040 over? They should have .060 pistons, too. Before I went even .060 on ANY block, I would have it sonic checked. If I went .080, I would have a very qualified machinist check it out. I know some engines can go as far as .125, but you have to find out on an individual basis.
Thread
Thread Starter
Forum
Replies
Last Post
hellbilly1932
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
3
Sep 4, 2007 01:11 PM
tom1979
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
16
Feb 14, 2007 09:35 AM
scottie2hottie
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
3
Jan 26, 2007 05:08 AM
Jackflack
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
9
Nov 3, 2003 09:32 PM
