4 Lo problem
Thread Starter
|
New User
Joined: Aug 2003
Posts: 8
Likes: 0
4 Lo problem
I know that you are not supposed to use the 4wd lo unless you are stuck in the snow or the mud, or in an extreme situation, but the other day i tried to turn it on to see if it works, and it did not even light up. I was wondering if it was a problem or if it didn't come on because i didnt need to use it, any help would be appreciated
Postmaster
Joined: Dec 2001
Posts: 3,742
Likes: 2
From: UT
You also have to have the transmission in neutral (P isn't even good enough) and have to be almost completely stopped ( I think the t-case module will accept <3mph, but at that point, with your foot on the brake, you just as well be stopped.)
If that doesn't get it to shift, then the next likely problem is a dirty shift motor (quite common). There are a few places on the net (www.ford-trucks.com has one) that describe how to take the motor apart and clean it up.
If that doesn't get it to shift, then the next likely problem is a dirty shift motor (quite common). There are a few places on the net (www.ford-trucks.com has one) that describe how to take the motor apart and clean it up.
Thread
Thread Starter
Forum
Replies
Last Post
