converting from npi to pi
Thread Starter
|
Senior User
Joined: Mar 2014
Posts: 126
Likes: 1
converting from npi to pi
97 f150, 4.6 liter. I did a engine swap a while back, switched from a Windsor to a romeo, at the time I didn't know I was switching to performance improved head and intake. I wasn't ready to do this so I used npi intake. Everything ran great for a while, now I'm wanting to convert to pi intake, I put pi intake on and there seems to be two problems. Pi intake does not have the two temp sensors on the front. I do know there are two sensor spots on the side of the head bank one. I'm not sure how to go about this, does anyone know how? Problem two, upon excelleration, shakes and rattles for a bit until I step on it. Seems like it's running out of gas. I'm thinking maybe it's getting to much air. Ecm is not compensating or correcting the error. And I'm getting no codes. Any information would be very much appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
79f100six
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
4
Oct 24, 2007 02:25 AM
mamafedmepaintchips
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
1
Mar 8, 2004 06:14 AM
