Yeah. Take my little diagram with you, and have them "splain it to you

 

I need to move out there and take care of the 'puter cars don don't want to fool with for crap's sake!

 

You're more than welcome to come out here and take care of ALL the damn computer cars. I won't touch them anymore.........

 

Planned on it. I had already found one of those, but I like yours better.

Stand by to Stand by. Our wonderful replacement Gov just signed the Oregon Cap & Trade bill, so we will have much "cleaner" fuel for our engines. They are going to get it so clean we shouldn't need to have any of the pollution control junk on the motors anymore!

 

Have a great day guys. Heading up on the roof to strip more roofing off. Sunny and warm out...

 

Have a good one Don. Don't fall off or through the roof. I'm off to fetch father and run him into town.

 

LMAOatU. Ya'll just got a re-hashed Md emissions program. basically, you pay more at the pump, and pay to be inspected!
win win for the state!

 

Afternoon Folks! My dragon tried to gore me, couple good cuts and since I was welding on it I ended up with 7 burns. all on the left hand too, even with light gloves I am not precise enough so, bare hands and pliers =

Anyhow, it was a good day as I managed to get a class at Clackamas Community College, WLD-100 welders blueprint reading 1. All paid for by the HS after a lot of work and beating through their lies...

 

Evening Gents! Haley and I have got 2,000 sf of roofing removed. Only another 4,000 left to go.....

 

Evening Don, Dustin and all that follow. Was feeling pretty bad this morning, so I was not talking much... Better by noon. Had to run to Redmond for supplies, then came home and worked on the shower. Looks like this:

 

Good job Allen! Looking very nice!

 

Thanks Don, grout, seal and clean up; it will be done. Then just ordering the doors, that is the hard part; $1000 for the shower doors!!

 

Ouch! Not cheap!

 

No, not cheap, custom made doors, from Lowes.

 

Good evening Oregon and everyone everywhere else. Clouds burned off and we had a nice sunny day from around 1000 this morning.

Got father in to get his car. They did replace the solenoid and the engine ECL is extinguished. What they were talking about was that they can not get the codes to clear from the PCM. Light is out, but the codes that turned the light on are still there????? Thinking I should put my scanner on it, confirm that codes are in fact present and try clearing them with mine. They cleared just fine the other day, but then came back a few seconds after the car was started.

On another front, I'm thinking I might be developing a starter problem. Went to start the pickup this morning and it didn't seem like the batteries had the power to do it. Had them checked when I was in town and they tested just fine. The fellow that tested them agreed that the starter didn't sound like it was turning the motor over the way it should.

That is looking very nice Allen. Wow, those are spendy doors! Dream Line, Allen + Roth or just gold plated?
I've been putting the Warden off for some time and it won't be long before I have to sell the boat and half my fishing poles to get her the "garden jet tub" and shower she has been wanting. Problem is, I think we'll have to add on to the house to have enough bathroom to fit it into.