head stud install
Lead Driver
Joined: Oct 2010
Posts: 5,420
Likes: 16
From: Ouray, CO
From other posts and videos….
There isn't enough clearance to insert the rear studs once the head is installed because the windshield header is in the way.
The "trick" is to insert the rear sets of studs into the heads BEFORE you put the head on to the block. Folks use cable ties on the studs to keep the studs from completely seating to keep the stud from sticking out the bottom and messing up your new gasket while you slide the head into place.
There isn't enough clearance to insert the rear studs once the head is installed because the windshield header is in the way.
The "trick" is to insert the rear sets of studs into the heads BEFORE you put the head on to the block. Folks use cable ties on the studs to keep the studs from completely seating to keep the stud from sticking out the bottom and messing up your new gasket while you slide the head into place.
Token Redneck
Joined: Jun 2007
Posts: 9,337
Likes: 346
From: Breckenridge, TX
You can remove the HVAC box heat shield and cover to gain clearance on the passenger side. You have to egg in the cab just a little on the driver's side to clear a torque wrench.
Having the bracket to hold the heads at the correct angle helps with the cab on:
https://www.ford-trucks.com/forums/1...l#post12575219
Having the bracket to hold the heads at the correct angle helps with the cab on:
https://www.ford-trucks.com/forums/1...l#post12575219
Strokin Okie
Joined: Apr 2004
Posts: 1,883
Likes: 21
From: Oklahoma
This would be a nice to have tool for HG replacement!
SRD35, Torque Adaptor, Diesel Head Bolt, 6.0L Power Stroke Engines
SRD35, Torque Adaptor, Diesel Head Bolt, 6.0L Power Stroke Engines
Thread
Thread Starter
Forum
Replies
Last Post
F-250 restorer
Ford Inline Six, 200, 250, 4.9L / 300
8
Dec 8, 2017 05:43 PM
wiccantoy
Pre-Power Stroke Diesel (7.3L IDI & 6.9L)
1
Mar 29, 2008 07:34 PM
