Need Some Help with efI COnversion
Thread Starter
|
Junior User
Joined: Dec 2005
Posts: 54
Likes: 0
Need Some Help with efI COnversion
Ok heres the story i have a 1993 Ford flareside 302 5speed. I am under the procces of converting it to a mustang speed density wire harness. But There are 2 promblems i'am concerned with
1 how dose the ecm get turned on? When i turn the key how dose it know to go in to run mood per say.
2 Is this engine goign to run right with the speed density, is the cam going to be compatible with the engine ?
1 how dose the ecm get turned on? When i turn the key how dose it know to go in to run mood per say.
2 Is this engine goign to run right with the speed density, is the cam going to be compatible with the engine ?
Last edited by Chevy_impala57; Jan 14, 2006 at 12:42 AM. Reason: wrong title
Postmaster
Joined: Aug 2001
Posts: 4,270
Likes: 5
From: Delaware
The key 'on' should close some relays, one of which powers the ECM.
If you have a cam, you are better off with a Mass Air, than a speed density.
In any case you need to tune the computer to the motor. You will have to take it to a shop or buy a DIY tuner.
If you have a cam, you are better off with a Mass Air, than a speed density.
In any case you need to tune the computer to the motor. You will have to take it to a shop or buy a DIY tuner.
Thread Starter
|
Junior User
Joined: Dec 2005
Posts: 54
Likes: 0
Hey thanks for all the reaplys, but i have changed my strategy a little bit, i got a mass air sensor and a mass air ecm from ebay , and i'am no longer using the mustang harness.
U can check it out if you want
http://www.cardomain.com/ride/2205396
U can check it out if you want
http://www.cardomain.com/ride/2205396
Thread
Thread Starter
Forum
Replies
Last Post
octaneforce
Ford Inline Six, 200, 250, 4.9L / 300
4
May 9, 2013 10:07 AM
robertbourque
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
6
Jan 18, 2007 05:58 AM
jklennon
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
7
Dec 30, 2006 09:56 PM
Hartwood
1987 - 1996 F150 & Larger F-Series Trucks
5
Nov 17, 2001 05:36 PM
