anyone know where i can find a blowup of a t-98 , especially the outside odds and ends ?? i tried novak and a couple of others but no luck . i need to know wether it was a rollpin / tension pin , or some sort of goofy fastener that went into the drivers side and into the notch on the shifter . been awhile since these / this one has been out and norm nor i have any idea where the lil' peices are and what they were now .

 

Will these help?:

 

heya Kevin. I sent your bracket out Friday noonish.
JML

 

ok john , and thanx . bob yes and no . still needing to figure out what the hades was holding the shifter in place . lil' hole on the drivers side that runs through into the side of the shifter where there is a slot in it . i'm sure it was a roll pin / tension pin , but wanna be sure it wasnt some funky fastener as we all know just when you think you know what you're doing .................... again thanx john !!!!!!!

 

It's just a quarter inch by about a three eighths roller bearing (at least that's what I use). The shifter cap holds it in on one side and the shifter ball holds the other, pretty simple. Tom

 

well now see kinda like what i remember .... so now ill roll doen to the farm store and raid the weirdo bolta bins and be on my way !!!!!!!!!!!! thanx tom !!!!!!

 

Here's more:



Can't let you have all my info at once.

 

thats the pic i needed bob ! thanx . no.7221 . already been down to the farm store { big r } and got what i needed and it's together .