REMOVING drivers side headlight
FTE Legend
Joined: Jun 2006
Posts: 31,930
Likes: 1,499
From: Ottawa, Ontario
Remove the grill and the wiper fluid resovoir. There are 2 bolts on the front side of the rad support, should be pretty obvoius. There are also 2 or 3 more behind the fluid resovoir. The whole headlight/turn signal assembly should come out when you get them all.
Elder User
Joined: Nov 2005
Posts: 834
Likes: 0
If you are working on a 1990, you don't have to pull the resovoir. Had mine out couple times in the last year, and didn't touch the resovior. Pulled the grille to get the front bolts, and reached around the resovior all the way to the outboard edge to get the other two. Don't remember the size, but had to use a deepwell 1/4 drive socket on them. Seems like there was one bolt in the front that was attached to the lower valance between the bumper and the grille.
Good luck Frank
Good luck Frank
Thread
Thread Starter
Forum
Replies
Last Post
