bullet proof bottom end

Reply Subscribe

Thread Tools

Search this Thread

Aug 9, 2006 | 12:22 PM

#16

bronco521

Elder User

Joined: Jul 2006

Posts: 688

Likes: 0

From: right here in michigan

have you guys seen the MPG port plates ?they fill the bottom of the exh port.i think the name of the place is mpg heads in colorado.

Aug 9, 2006 | 02:17 PM

#17

backwoodspuller

Thread Starter

Senior User

Joined: Dec 2005

Posts: 239

Likes: 0

thanxs guys i am rilly thankful for the good advice i am gonna go with cast steel crank but i am gonna most likely swap it out for a forged one on the winter cause i am takeing old spare and left over parts and i am gonna build the wife a motor for stock class that should work just fine for that but this way i get my motor up and runing and i can finsh the seson terrys truck is sweet sounds very nice they also changed our rules so we dont have a 850cfm limit any more just a 4150 flang limit so i am gonna for shure invest in a new carb i will let ya guys know how it turns out i am gonna try to order it today and if anyone has an idea about oiling systems i want to block of some oil and keep in the bottom i was told i can block of a oil gally is some 460's but in otheris it also blocks it going to the mains?