4" stainless dp back exhaust

Reply Subscribe

Thread Tools

Search this Thread

Jul 13, 2006 | 08:06 AM

helpfulguy

Thread Starter

Freshman User

Joined: Jan 2006

Posts: 49

Likes: 0

4" stainless dp back exhaust

well i finally broke down and installed a magnaflow exhaust from the downpipe back. I was not really ready to do it financially but got a great deal on the setup so i bit the bullet and bought it. I was suprised at how easy the install was, the complete job took less than 2 hours and if i would have done it on a lift it would have been faster. the only thing that i don't really like about the system is the ID at the dp connector, If i find a downpipe later on that is a little bigger I will still have a restriction were it joins to the rest of the system.

Jul 13, 2006 | 02:22 PM

ToughBuiltFord

FTE Sponsor

Joined: Jun 2006

Posts: 662

Likes: 0

Congratulations, A mod worth taking no doubt

Jul 13, 2006 | 04:14 PM

willbd

Senior User

Joined: Jul 2005

Posts: 463

Likes: 2

From: Woodburn, OR

What did the system cost you?

Jul 14, 2006 | 04:25 PM

helpfulguy

Thread Starter

Freshman User

Joined: Jan 2006

Posts: 49

Likes: 0

well it cost me roughly $260.

Jul 14, 2006 | 04:42 PM

willbd

Senior User

Joined: Jul 2005

Posts: 463

Likes: 2

From: Woodburn, OR

That's a good deal. How did you get for such a low price?

Jul 14, 2006 | 06:20 PM

helpfulguy

Thread Starter

Freshman User

Joined: Jan 2006

Posts: 49

Likes: 0

i friend of mine got it from is bro-in-law who has a little shop. basically that is the cost of the system, anything over that is mark up. of course why sell them if you can't make a profit.