Jacking up engine
Thread Starter
|
Elder User
Joined: Dec 2004
Posts: 718
Likes: 0
From: North Jersey, New Jersey
Jacking up engine
I just got my oil pan partially down and loosened the motor mounts where do I jack up the engine from???
I will be using a block of wood on my jack to prevent damage to the metal.
Do I jack it up by the torque converter???
I will be using a block of wood on my jack to prevent damage to the metal.
Do I jack it up by the torque converter???
FTE Community Team
Joined: Nov 2001
Posts: 1,825
Likes: 248
From: Oak Harbor, Washington
When I took my pan off two years ago Christmas ('89 shorty 3.0l AT), I had to jack up the engine about 1.5 inches to get the pan to clear the crossmember. I used a block of wood on the bottom of the harmonic balancer, and jacked against that. Worked perfectly. Watch the fan blades, you go any higher, you might break one. I carefully bent mine while jacking, and didn't loosen the fan shroud, but YMMV.
Regards,
Al S.
Regards,
Al S.
.
Thread
Thread Starter
Forum
Replies
Last Post
