When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
FWIW, I don't understand why you just can't install the original brake line into the port on the MC. When I replaced my MC a few years back, the old one had some adaptor brass fitting. I just threaded the old original brake line into the new MC. My new brake parts come from my local NAPA.
That is what I said in post #13 just put the line back into the master.
Even more so being he is not going to use the trailer brake controller.
Dave ----
That is what I said in post #13 just put the line back into the master.
Even more so being he is not going to use the trailer brake controller.
Dave ----
I missed that. But yeah if the tee was close coupled to the master should he able to do that.
I missed that. But yeah if the tee was close coupled to the master should he able to do that.
Also at the time I did not know he was not going to use the brake controller but needed to move the truck so I said to use a coupling in place of the Tee till he could get all the needed fittings.
There were a few ways to skin that cat.
Dave ----
