Compressor Quandry
Hotshot
Joined: Dec 2014
Posts: 17,824
Likes: 3,104
From: Jersey Shore
No, I did not, but I’m OK without.
Once I saw the pitch change in the threaded area used as the control or “weaker of two springs” (the shank being the higher rate spring) and the consistency of thread formation, I found I could use the pitch as the length change. I thought I was going to have an issue if they rolled the thread after hardening, but it looks like the manufacturer rolled before - so the thread area yields first.
Once I saw the pitch change in the threaded area used as the control or “weaker of two springs” (the shank being the higher rate spring) and the consistency of thread formation, I found I could use the pitch as the length change. I thought I was going to have an issue if they rolled the thread after hardening, but it looks like the manufacturer rolled before - so the thread area yields first.
Thread
Thread Starter
Forum
Replies
Last Post
tsbrewers
1968-Present E-Series Van/Cutaway/Chassis
8
May 22, 2012 07:29 AM
krewzn_along
1997 - 2006 Expedition & Navigator
1
Jan 12, 2006 12:16 PM
