351M throttle cable problem
Thread Starter
|
Mountain Pass
Joined: May 2012
Posts: 186
Likes: 1
From: Voorhees NJ
351M throttle cable problem
I have a problem with a 351M throttle cable. I have an issue keeping the end of the cable on my carb. I have a 600 Holley carb with factory style cable. It pops off the ball on the carb every so often. I’ve replaced the ball and cable, but still have the problem. I also installed a throttle cable bracket instead of just using the factory set up. I’ve tried putting more tension on the clip on the cable, but it’ll still pop off. It doesn’t do it all the time, but it’s annoying when it happens ( usually the most inconvenient time). Any help or thoughts appreciated.
Logistics Pro
Joined: May 2015
Posts: 4,474
Likes: 972
From: Tri Cities, TN
Sounds like the spring clip that snaps over the ball may be the wrong size for the ball. If the cable you have is aftermarket it may be metric. I used an aftermarket cable and had to use the clip from the old Ford cable.
Moderator
Joined: Nov 2007
Posts: 22,415
Likes: 92
From: Denver Metro Area, CO
I posted this out here someplace recently, I'd try different *****, they're cheap
https://www.holley.com/products/fuel...age/parts/20-2
https://www.holley.com/products/fuel...age/parts/20-2
Thread
Thread Starter
Forum
Replies
Last Post
Marty in PA
1961 - 1966 F-100 & Larger F-Series Trucks
4
Apr 30, 2012 07:07 PM
yozsi
Ford Inline Six, 200, 250, 4.9L / 300
23
Jan 29, 2005 12:36 AM
