When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
1956 Ford F100 Y block fan spacer. This spacer is listed in the parts book as being 2.30" long and has a 3/4" pilot hole on the back of the spacer. Any assistance is greatly appreciated.
For Sale: 1946 Truck seat
As I was browsing Craigslist I came across this seat someone may need. It is in Alabama north of the center of the state. Link below. 1946 truck seat
WTT complete long bed for a complete or semi complete short bed
I have a complete long bed that is in good shape, only surface rust and the old paint on. I have the long running boards that are also in good shape. I can include the tailgate if the short bed comes with the tailgate as well. Thank you.
The long bed tailgate is higher and wider than the F100 tailgate. Don't scrap any of it.
yea I figured. I was thinking of cutting it, but I think it would be easier for me to just try to find a used one. Just that some people want way too much for a tailgate.
yea I figured. I was thinking of cutting it, but I think it would be easier for me to just try to find a used one. Just that some people want way too much for a tailgate.
what kind of shape is yours in? Do you have a photo? I have a NOS short bed tailgate that I painted for my my truck before realizing it wouldn’t fit (long story).
what kind of shape is yours in? Do you have a photo? I have a NOS short bed tailgate that I painted for my my truck before realizing it wouldn’t fit (long story).
it just need sand blasting and it would be good for the paint booth
Hey Fellas,
I am moving and these things are not going with me, so if anyone wants them come get them or pay for shipping, otherwise they will be scrap in about a month. I rebuilt all my wheel ends on my 51 F5 then went a completely different direction with the build, so all the drums, shoes, bearings springs, adjusters, etc. were either new or rebuilt. I am located in Gardnerville, Nevada. I also have the entire rear end with the wheel ends on it, which is yours also. PM me up if you are interested. Complete rear end Front Left Front right, drum didn't get painted
I have a 51 F1 with whats left of a 226 in it, I have a 8BA to replace it. I was told when I got the truck someone pulled the head because it had a blown head gasket, the head is missing but everything else is there. The engine is froze up from being rained in over the years. The block is probably salvageable if someone needed it, otherwise its just parts. Your welcome to it or the parts you need if you want them, all you need to cover is shipping. I'm located in the panhandle of Florida send me a PM if you need anything.
Yea still have to pick one up, but need a radiator and front upper fenders as well, picked up a grille at the Grand national F100 reunion for it this year. Still have a little ways to go on it but its coming along. Can't wait to crank the old flattie for the first time been a while since i've heard one run.
Originally Posted by petemcl
Don't forget to install the correct hood baffle or you may have overheating problems.
The truck had about 19,000 miles on it when I bought it. Mice crawled through the exhaust and into the cylinders, otherwise I don't think it would have been locked up. I couldn't un-stick it. I put a rebuilt 292 Y in the truck. I haven't done much on it lately, but the bed is getting prettied up as we speak. I still have interior work to do, but it's drivable!
Probably too late, but if you’re interested in “unsticking” your engine, try putting some marvel mystery oil (MMO) in each cylinder and let it soak.
05-24-2021, 11:20 PM
