Console stereo controls removal
#1
#2
If you lift up the console lid, high on either side of the rear wall is a pair of T-20 Torx screws. Remove those. Then in the rear of the console open the ash tray and there are a pair of phillips screws to remove. Then just yank the rear panel back and off to free the clips. Unplug the harness, and it should be free.
#3
If you lift up the console lid, high on either side of the rear wall is a pair of T-20 Torx screws. Remove those. Then in the rear of the console open the ash tray and there are a pair of phillips screws to remove. Then just yank the rear panel back and off to free the clips. Unplug the harness, and it should be free.
Thread
Thread Starter
Forum
Replies
Last Post
goober22
Explorer, Sport Trac, Mountaineer & Aviator
2
02-02-2014 01:37 PM