New timkens. Stud thread question.

Reply Subscribe

Thread Tools

Search this Thread

Jun 18, 2019 | 11:44 AM

#16

bluovl

Laughing Gas

Joined: May 2011

Posts: 855

Likes: 40

From: SoCal

Quote:

Originally Posted by BlackTruckDave

I'm not looking for LUG NUTS for the wheel. Of course I could find them anywhere.
I am looking for solid Flange Nuts that bolt the Timken Hub to the Knuckle.

Sorry I got confused. Why can't you use the old one's? Ok did I miss something else. I'm about to do the same job on my 02'. Here's the parts I have. I have coarse thread wheel studs. Flange studs look to a "coarse" thread also.

Knuckle studs are threaded the same on both ends.

Jun 18, 2019 | 12:55 PM

#17

BlackTruckDave

Mountain Pass

Joined: Feb 2007

Posts: 208

Likes: 1

From: Mars Hill, North Carolina

Here is what i ordered:
https://www.belmetric.com/fine-threa...nc-p-9732.html
$1.48 each
Hope you try those nuts on the stud threads first cause I have my hub installed and the thread locker on them but I did not try the nuts before I got so involved so I am dead in the water until these arrive. I got 8 because I am doing both front hubs. I just cannot see paying FOMOCO $8 a piece