Fan Shroud source

Reply Subscribe

Thread Tools

Search this Thread

Apr 29, 2019 | 04:42 PM

#16

AbandonedBronco

Thread Starter

Moderator

Joined: Dec 2007

Posts: 7,987

Likes: 104

From: Boise, Idaho

Thanks for the pics and for the information.

I tried to install the shroud that I got, but it was a no-go. It was just too deep, and interfered with the pulleys/belts. I also couldn't get it past the snout on the water pump.
I'm guessing it was meant for a single row radiator.

The shroud you have looks shallower than the one I found, so I need to find one like that. I'll have to check the other two junk yards and see what I can find. We have four total, which is nice.

Quote:

You rang? Lurch (Ted Cassidy) lived in Santa Monica Canyon just south of Sunset Blvd. His name, address and phone number were listed in the westside telephone book.

It wasn't long before people were ringing his door bell and when he opened the door, they yelled YOU RANG? He got so fed up with this...that he sold his house and moved.

How frustrating! Poor guy.

May 23, 2019 | 03:44 PM

#17

greyghost85

Postmaster

Joined: Jun 2007

Posts: 3,856

Likes: 1

From: Lebanon

Did you find a fan shroud? Saw a guy on tv, make one. It actually didn't look that difficult

May 23, 2019 | 04:44 PM

#18

FuzzFace2

FTE Legend

Joined: Nov 2015

Posts: 30,960

Likes: 4,129

From: Angier, NC

Quote:

Originally Posted by greyghost85

Did you find a fan shroud? Saw a guy on tv, make one. It actually didn't look that difficult

And it only took him 5 mins to do it too LOL
Was that for the RX7? If so he had to make one as that was an aftermarket radiator and was larger than stock.

The money I paid for mine and the little trimming it needed to fit was well worth it.
I am sure it would fit his also as it looked like all the shrouds bolted up the same way.
Shroud slips into clips at the bottom and the 2 bolts at the top.
The shroud was for 95/96 trucks with the 300 and I have it bolted to an 81 radiator.
Dave ----