Help with body code

Reply Subscribe

Thread Tools

Search this Thread

Dec 28, 2015 | 02:18 PM

cworthington

Thread Starter

Freshman User

Joined: Feb 2015

Posts: 41

Likes: 0

Help with body code

GEM code B1359 Ignition Run/Acc Circuit Fault

Some background info-
2001 F250 S/D 5.4 auto tranny single cab.
Truck was flooded, i believe to the roof, maybe went into a river? I bought it as is.
We replaced fuse panel, gem, all relays and fuses and flushed diffs, tranny, engine, and t-case. We also replaced radio and relays behind it. Replaced the ignition switch and cluster as well. We cleaned most of the connectors out with compressed air. This truck runs fine, almost perfect.

Symptoms-
Windows dont work unless i wait 22 seconds, then the truck beeps, and door ajar light comes on and then the windows work. Windows dont work in acc. mode but the radio does. I also get this code B1359 ignition run/acc circuit fault. Wont go into 4X4 unless i wait the 22 seconds, along with the washer fluid pump.

Causes-
Clueless, any help is appreciated, even if its barely related.

Dec 28, 2015 | 04:57 PM

ligito

Posting Guru

Joined: Nov 2008

Posts: 1,229

Likes: 2

From: Oregon

Are you from Missouri?

Dec 28, 2015 | 05:36 PM

Just Strokin

Post Fiend

Joined: Nov 2001

Posts: 6,748

Likes: 118

From: Tallassee, ALabama

One search talked like it was the Ignition Switch bad. Might be shorted some place.

Definition of Diagnostic Trouble Code B1359

Ford:
Ignition Run/Acc Circuit Open Or Short To Ground

Diagnostic Trouble Code (DTC) B1359 Definition

Dec 28, 2015 | 07:16 PM

bayou barataria

Posting Guru

Joined: Jul 2007

Posts: 1,543

Likes: 0

May still have moisture somewhere causing an intermittent short. If it is the ignition switch try spraying some wd -40 into the assy. before removing it. If it has already been submerged I don't think it would hurt to try, you would be surprised how it can displace moisture. I had a few drops of water in the trim switch on the throttle assy. on my boat and every now and then I would find one of the motors trimmed all the way up on the lift. I just cleaned it out and sprayed some wd-40 into the assy and it has been fine since. Could be moisture or corrosion in the wiring harness connectors also.

Dec 29, 2015 | 08:54 AM

cworthington

Thread Starter

Freshman User

Joined: Feb 2015

Posts: 41

Likes: 0

From PA. I forgot to mention i already replaced the ignition switch. Any other ideas?

Dec 29, 2015 | 08:56 AM

cworthington

Thread Starter

Freshman User

Joined: Feb 2015

Posts: 41

Likes: 0

Disregard.

Dec 29, 2015 | 09:15 AM

cworthington

Thread Starter

Freshman User

Joined: Feb 2015

Posts: 41

Likes: 0

http://repairguide.autozone.com/znet...3f8023cbb0.gif

Im not sure if you have to join autozone website to view this, but its free to join if you have to. I found a picture of the switch with some brief description. Its enough to go on for now.

I also found this,
http://www.thedieselstop.com/faq/949...es/k14670b.gif

Anybody know voltages at specific wires?

10 Things Every Truck Owner NEEDS (2026 Edition)

Michael S. Palmer

Rezvani's Latest Post-Apocalytic Monster Is a Ford F-150 Raptor Underneath

Verdad Gallardo

Top 10 Most Expensive Ford Trucks Ever Sold on Bring a Trailer

Joe Kucinski

2027 Ford Super Duty Buyer's Guide (Every Model, Engine, & Package)

Brett Foote

Top 10 Ford Truck Tragedies

Joe Kucinski

AEV FXL Super Duty - the Super Duty Raptor Ford Doesn't Make

Brett Foote

Lobo Vs Lobo: Proof the F-150 Lobo Should Be Even Lower!

Michael S. Palmer

Ford's 2001 Explorer Sportsman Concept Looks For a New Home

Verdad Gallardo

10 Best Ford Truck Engines We Miss the Most!

Joe Kucinski

2026 Shelby F-150 Off-Road: Better Than a Raptor R?

Brett Foote

Dec 30, 2015 | 11:44 AM

bayou barataria

Posting Guru

Joined: Jul 2007

Posts: 1,543

Likes: 0

Man, if the truck was submerged it could be anything. maybe you should bring it to a shop that has dealt with that if you can find one. That is the bad thing about a flood it ruins everything, in a house too.

Dec 30, 2015 | 04:12 PM

#10

cworthington

Thread Starter

Freshman User

Joined: Feb 2015

Posts: 41

Likes: 0

I mean its drivable and stuff and if people don't mind the 22 second wait then its good, but its more of an inconvenience. Trying figure it out. If i cant itll have to do the way it is. Just trying to find something that will get me closer, like wiring diagrams and supplied voltages and stuff.

Dec 30, 2015 | 06:23 PM

#11

bayou barataria

Posting Guru

Joined: Jul 2007

Posts: 1,543

Likes: 0

if it is a delay but still works I would guess low voltage to the computer or malfunctioning computer.i know it is a long shot but did you try resetting the computer by disconnecting the power?