Ford Truck Enthusiasts Forums - View Profile: Just Strokin

Go Back  Ford Truck Enthusiasts Forums > Members
Reload this Page >

Just Strokin's Profile

Just Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud ofJust Strokin has much to be proud of

Just Strokin Just Strokin is online now


Visitor Messages

Showing Visitor Messages 1 to 10 of 12
  1. rfree
    08-02-2018 09:27 AM - permalink
    I have a forscan ? Trying to enable DPF%. My code now is 720-01-01 EA20-BA20-EF5F
    When I change the value from B to 9 I get a checksum error. I do have compass enabled from factory so that value does not match either. I noticed most people have are EA21 where I have EA20. Any suggestions
  2. bbq guy
    10-27-2017 10:39 AM - permalink
    Just wonder if you seen my post last night about what the parts guy said? Since I am new to all of this and I was wondering what you thought.
  3. JetExpress_6.7
    12-02-2016 07:59 PM - permalink
    Dropped you a PM over on the .org, when you get a chance check it out Thanks!
  4. Just Strokin
    09-13-2016 01:25 PM - permalink
    watch the video on how to install basically start by installing only the v81 calibrations files and then install a full version of IDS
  5. gump2388
    09-13-2016 10:58 AM - permalink
    Thanks Just Strokin. I checked it out and it looks like just the ids is there. Do you know if the calibration files are normally in ids? I have the c81 files but it must be missing the calibration for my truck. Do you know how to download them on the ford website? When i put in my calibration it says no files found
  6. gump2388
    09-13-2016 09:27 AM - permalink
    I noticed you gave Terry a link to get the ids calibration files. do u still have that up? I'm looking to get a vcm2 to connect to my 2011 super duty.
  7. checheng
    05-25-2016 09:06 PM - permalink
    sorry I didn't see your message in my profile =D
  8. checheng
    05-25-2016 09:05 PM - permalink
    hi my email is [email protected] . thanks for helping me out.
  9. lmbbuilders
    03-13-2016 02:33 PM - permalink
    thanks, I appreciate it
  10. lmbbuilders
    03-10-2016 10:44 PM - permalink
    hi, I was reading a few forums and noticed you posted some wiring diagrams for other members. Im in need of some help, I have a 2005 f2520 6.0 diesel with electronic climate control and when my a/c comes on it throws several codes and disables my gas pedal. I know im loosing my 5v reference, but not sure where. I have replaced my compressor, alternator, batteries, low pressure switch, accumulator,oriface tube and disconnected several 5 v reference sensors and all gives me the same results. I know if I disconnect my low pressure switch my defrost and heater works fine, but this is not engaging my compressor. could you email some diagrams to help me troubleshoot? my email address is [email protected] either way, thanks in advance...hope to hear back from you.

About Me

  • About Just Strokin
    Tallassee, ALabama
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    Rather not say
    Miles per year
    Rather not say
  • Signature

    2015 F350 Ultra Lariat 6.7L CCLB DRW 3.73 Limited Slip, Green Gem Metallic w/ Caribou accent, Titan 65gal tank, Rapid Heat, Block Heater, Upfitter Switches, Dual Alternators, Camper Package, Cable Lock, Husky Floor Liners, 5th Wheel Prep, 25K 5th Wheel Hitch, Ford Goose Neck Hitch.


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 05:29 AM
  • Join Date: 11-30-2001
  • Referrals: 0

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.