New tool?
). Think it' too cheaply made to be useful? 640x480 on a 2.7in display, 4 LED's, 60° viewing angle, 1in to 10ft focus. Started to snag it but might be a good thing for Santa to bring. Any thoughts?
To go thru a glow plug hole it has to be smaller than 8mm. I think about 10mm for an injector bore.
I ruined the cheap one from harbor freight trying to go thru a glow plug hole.
Had that thing less than a hour LOL
summer had it's uses. There is one problem and I have this with
my nice Snap-On BK6000. You have to aim the tip where you need it to go.
I was SO spoiled by the fully articulated scope at school. It was small
enough that you could fit it into a spark plug hone and have a look around
with the steering controls.
Now for the santa thing. I have an extra Snap-On BK 6000 that I will
be selling. It needs the video probe repaired. Snap-On said they can
do that and it's a flat rate job of about $120.00 So thinking about that.
I'll put it in the classified section sometime soon.
Sean
BTW Snap-On makes a small probe 5.5mm if I recall right









