Rough Running after injector cups
Thread Starter
|
New User
Joined: Aug 2011
Posts: 11
Likes: 0
Rough Running after injector cups
Just got done doing the injector cups, was leaking in the coolant overflow tank. Installed the new cups and new orings on the injectors, started up ok, drove around the block and back to check fluids again. Go to drive again and stared running rough the CEL come on then goes off. I was reading that air can get trapped in the oil galley, and it will run rough for like 50 miles, but I cant really drive it so I'm seeing if anyone had a similar thing happen. Thanks
Logistics Pro
Joined: Apr 2010
Posts: 4,446
Likes: 25
From: Panama City, FL
If you had a CEL then there are codes stored. Get the codes read and post them here. You will need a good scanner to pull the codes. Most parts stores cant read our engine. We can throw out ideas but its still shooting in the dark without codes.
Yes the engine can run rough for up too 200 miles until all the air is out.
One thing to look at is the 9 pin connector on the in side of the valve covers. Make sure there plugged in all the way.
Yes the engine can run rough for up too 200 miles until all the air is out.
One thing to look at is the 9 pin connector on the in side of the valve covers. Make sure there plugged in all the way.
Thread
Thread Starter
Forum
Replies
Last Post
cabloom300
6.0L Power Stroke Diesel
10
Jan 24, 2014 06:39 PM
