When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey all, I have a 1999 F250 SD V10 4x4. I recently had a transmission installed and the truck is running erratic. I have an engine miss (sometimes when idling, more so when in drive and foot on the brake). I say sometimes because there are times it will not miss and the engine runs smooth. The transmission shifts a little strange and sometimes hard.
I am getting a code reading that says my TPS is faulty, but I installed a new one a few months back.
The engine is running rough (jerky on acceleration) especially when driving. I was wondering if I should take it to a shop and have them flash the computer to reset it?
(Side Note: I also remove the AC compressor a while back (bad clutch). No $ to replace. I installed an aftermarket pulley.)
take the truck again for a good code reading
But before that, reset the computer by disconnecting the battery negative wire, wait 5 minutes and put it back again and check if the truck will work better or not