New member, need some help
Thread Starter
|
New User
Joined: May 2013
Posts: 2
Likes: 0
New member, need some help
I recently purchased a very clean 78 F150 Lariat. The truck is in fantastic condition with the exception of a few rust spots on the bed floor. The original owner put a hard bed liner in when it was new.
I'm planning to replace the bed pan with one from LMC or NPD. Then I'll do a spray in liner. I have a mig welder and a plasma cutter, so I'm not a complete virgin with metal but I'm no body guy either. My first question is how is the stock bed floor attached and what's required to separate it from the inner bed sides?
I tried the search feature but didn't have any luck.
I'm planning to replace the bed pan with one from LMC or NPD. Then I'll do a spray in liner. I have a mig welder and a plasma cutter, so I'm not a complete virgin with metal but I'm no body guy either. My first question is how is the stock bed floor attached and what's required to separate it from the inner bed sides?
I tried the search feature but didn't have any luck.
Thread
Thread Starter
Forum
Replies
Last Post
Dave145
1973 - 1979 F-100 & Larger F-Series Trucks
10
Jan 15, 2012 12:44 PM
