MAP sensor signal voltages?
Thread Starter
|
New User
Joined: Apr 2013
Posts: 1
Likes: 0
MAP sensor signal voltages?
Hi all! Just became a member recently! Excellent site! I have a 99 F350 7.3L. I am building my own 3stage water/methanol controller. My question is...What is the voltage sent out at 0psi,...3psi, 4psi.5psi...up to the 20psi? I don't want to drive and try and look at the boost gauge and dmm. Bad things could happen. If anyone knows this info or where to find it I would greatly appreciate it! Thanks!
Posting Guru
Joined: Feb 2009
Posts: 1,325
Likes: 4
From: Blaine, TN
Welcome to the forums!
The map sensor sends an analog signal to the pcm, so its not measured in volts it is hertz.
Here is the only thing i have for the sensor.
0psi=111hz with koeo, may vary depending on baro.
5.3psi=130hz
15.3psi=167hz
25.3=203hz
The simplest way to make a controller is with a hobbs switch set at whatever psi you would like the system to come on.
Hope that helps you man.
The map sensor sends an analog signal to the pcm, so its not measured in volts it is hertz.
Here is the only thing i have for the sensor.
0psi=111hz with koeo, may vary depending on baro.
5.3psi=130hz
15.3psi=167hz
25.3=203hz
The simplest way to make a controller is with a hobbs switch set at whatever psi you would like the system to come on.
Hope that helps you man.
Thread
Thread Starter
Forum
Replies
Last Post
brichert
1999 - 2003 7.3L Power Stroke Diesel
10
May 26, 2017 06:46 AM
superduty4x4
1999 - 2003 7.3L Power Stroke Diesel
5
Apr 13, 2008 07:48 PM
