No start after chip installed
Thread Starter
|
Freshman User
Joined: Nov 2011
Posts: 34
Likes: 0
No start after chip installed
Just installed a hypermaxx chip in my 2003 7.3 F250.
The chip is for a 2002. Now when I go to start it I have no glow plug light and it just cranks. I remove the chip and it starts fine. Possible wrong calibration for PCM? Or did I not get the PCM cicuit board clean enough?
Thanks for the help.
The chip is for a 2002. Now when I go to start it I have no glow plug light and it just cranks. I remove the chip and it starts fine. Possible wrong calibration for PCM? Or did I not get the PCM cicuit board clean enough?
Thanks for the help.
New User
Joined: Apr 2004
Posts: 23
Likes: 0
Just installed a hypermaxx chip in my 2003 7.3 F250.
The chip is for a 2002. Now when I go to start it I have no glow plug light and it just cranks. I remove the chip and it starts fine. Possible wrong calibration for PCM? Or did I not get the PCM cicuit board clean enough?
Thanks for the help.
The chip is for a 2002. Now when I go to start it I have no glow plug light and it just cranks. I remove the chip and it starts fine. Possible wrong calibration for PCM? Or did I not get the PCM cicuit board clean enough?
Thanks for the help.
Thread
Thread Starter
Forum
Replies
Last Post
444dieselrod
1994.5 - 1997 7.3L Power Stroke Diesel
10
Nov 14, 2017 10:21 PM
89broncoll
1999 - 2003 7.3L Power Stroke Diesel
20
Nov 14, 2011 08:55 PM
Orr353
1994.5 - 1997 7.3L Power Stroke Diesel
11
Jul 3, 2011 02:39 PM
Seven-Point-Three
1999 - 2003 7.3L Power Stroke Diesel
4
Sep 15, 2010 08:52 AM
