Hi I'm Paul and I'm new.
That said, I want to do some programing work on my EEC 4 OBD1
I'd like to use a product from Tweecer, But I need to get my hands on the original Ford binary code as a starting point. It supposedly can't be downloaded from the computer directly.
Apparently I have a fairly rare truck. Go figure.
97 F250 7.5l. non CA.
My pcm is "ALT0".
And I can't find a source for the code.
Has anyone got any ideas?
Thanks ... Paul

 

I'm guessing that's an SD truck? If so you're probably not going to find the binaries but ask over on the Tweecer and Binary Editor forums.

 

EECTuning.org • Index page

They probly can help you on that forum. There was a site that had lots of EEiv roms people dumped ready for downloading, but I have not found it in some time.

 

You could e-mail or give Mike Glover of Tweecer a call and ask. I looked it up on his site and it's not listed as supported, but he doesn't have all of them on the site.

The TwEECer -- EEC-IV user programmable module

 

Keep in mind, just having the bin file will do nothing for you unless you have a resource file to support it (I'll assume you don't understand machine code).