Exhaust sound clips
http://www.youtube.com/watch?v=n4M44gfhXvA
Finally happy with it!
SI/ DO FlowSuper44.
3''/ 2.50''/ 3'' tips.
Cold start;
YouTube - F150 Cold Start / Mounting Ramps
Short acceleration;
YouTube - Driving vid for Motorhead
At idle;
YouTube - 94 F150 FlareSide Walk Around
A drive by; I plan on taking a better one sometime. I couldn't get on it like I wanted.
YouTube - F150 Passing by
Six in a row makes it go.
Check out the frame flex. I thought it was pretty good considering it's a 2wd. Ford makes some excellent trucks. Even the cheap-o models like mine are still tough. All I need now is a rear locker.
96 F150 longbed single cab
both cats chopped off and true duals start where the downpipes would normally converge at the first cat, from there they each go into a walker high flow cat and continue over the rear axle and out the sides, the pipe is 2 inch with 3"x18" tips. this system has about 3 years of use on it
YouTube - True duals on an inline 6

YouTube - Ford 300 I6 Modded w/Flowmaster
Specs:
1980 Ford F100 Flareside - 300 I6 (dur
)- Stock cam, EGR & A.I.R. Pump deleted
- Holley 470 Truck Avenger
- Offenhauser C-Series w/ 2 inches of carb-spacer
- Hedman Header
- Dual 2 inch pipes from collectors
- Cat-less
- Flowmaster 40 series (2 into 1) with 3 inch exit, dumping behind rear of the cab.
High idle ~850-900 RPM, Revving to 3400 RPM, and Idle with Load at ~500 RPM
300 w Raptor, sound clip
Ford Trucks for Ford Truck Enthusiasts
Ford 300 I6 Modded w/custom Gibson exhaust
It lost some of the muscle car sound, but it's a lot nicer on the inside taking a long trip (and my truck is a Custom, which means no sound proofing).
glasspack into a 3 inch tip
YouTube - 1994 F150 with the 300 Inline 6
keep in mind it is a cold start
YouTube - truck walk around and exhaust
http://www.youtube.com/watch?v=0hsg4SDoUYc
http://www.youtube.com/watch?v=ssLcysape6w
http://www.youtube.com/watch?v=ZhL0jJ7krhA












