Offenhauser 300 intake I.D. Help Please!
Thread Starter
|
Trailering
Joined: Dec 2022
Posts: 22
Likes: 32
From: Galion Ohio
Offenhauser 300 intake I.D. Help Please!
Need help with an I.D. on this Offenhauser intake that I just picked up. It seems to be an early one, but I cannot find any that are quite like it.
It is not a "dual port", and the "c series" that I see do not have the 4 individual holes, but an open plenum from the carb mount.
The only markings on it are "360" and of course the "Offenhauser" insignia.
it is a split runner system. The "engine side" two holes are divided from the "outside" two holes, and the "wall" ends right in the center of the runners going to the second from the end cylinders (cyl # 2 and 5)
Anyone seen one before?
It is not a "dual port", and the "c series" that I see do not have the 4 individual holes, but an open plenum from the carb mount.
The only markings on it are "360" and of course the "Offenhauser" insignia.
it is a split runner system. The "engine side" two holes are divided from the "outside" two holes, and the "wall" ends right in the center of the runners going to the second from the end cylinders (cyl # 2 and 5)
Anyone seen one before?
Thread
Thread Starter
Forum
Replies
Last Post
66peoriaaz
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
13
Feb 25, 2026 06:27 AM
mac1gt
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
5
Sep 14, 2021 09:19 AM
