Ignition module help

Reply Subscribe

Thread Tools

Search this Thread

Jun 23, 2018 | 02:31 PM

vettman

Thread Starter

Tuned

Joined: Jul 2001

Posts: 432

Likes: 38

Ignition module help

I'm trying to replace the ignition module on my 1976 F350, but I can't get the plugs to separate. I've tried prying up on the retainer clips and pulling, but can't seem to get them to budge. I'm sure I put dielectric grease on the terminals when I installed the old one 5 years ago. If anyone can offer advice, I would certainly appreciate it.

Thanks

Jun 23, 2018 | 06:18 PM

flatbedfordguy

Elder User

Joined: Apr 2018

Posts: 567

Likes: 3

They can be very stubborn but they will eventually pull apart if you keep trying. You can always put a pair of channel locks on either end and work them apart if need be.

Jun 24, 2018 | 01:54 AM

1TonBasecamp

Lead Driver

Joined: Jul 2017

Posts: 9,601

Likes: 1,174

From: San Jose, CA

I've never yet been able to pull older ones apart without breaking (or at least permanently bending) the two tabs. And even when broken off, the two halves don't always come apart willingly.
Like flatbed said, keep worrying at it and they will eventually part ways.

Good luck.

Paul