Foil delete. NOW HELP NEEDED! IC BOOT AND CLAMP PROBLEM
Senior User
Joined: May 2010
Posts: 407
Likes: 0
From: Southern IL
You can also paint them.
http://i1013.photobucket.com/albums/...d/DSCF1522.jpg
http://i1013.photobucket.com/albums/...d/DSCF1522.jpg
Yep, I've been thinking about that as well
Thanks.....Tom
Hook it, I'll pull it.
Joined: May 2007
Posts: 15,037
Likes: 4
From: Grand Lake, La.
Brent, you probably stuck the pipe too far in the boot at the IC. Try pulling a little out and put more to the boot at the spider.
Post Fiend
Joined: Nov 2007
Posts: 9,549
Likes: 14
From: Payson, AZ
The stock boots have a groove that lines up with a ridge on the IC tube. You should be able to feel it when the two line up. The clamp goes between the lines on the boots which should be right over where the groove and ridge line up.
Thread Starter
|
Senior User
Joined: Jun 2008
Posts: 272
Likes: 0
Yea I got it to seat in there and clamped between the lines. It stays good till it gets tight then when i tighten it down the clamp slides out of the lines twords theother clamp. I might take it off and unclamp the other side. Tighten it up so its not on an angle then try clamping the other bracket since its bigger.
My filter from Clay (RiffRaff) will be here tomorrow so Ill prob do it then.
My filter from Clay (RiffRaff) will be here tomorrow so Ill prob do it then.
Thread
Thread Starter
Forum
Replies
Last Post
DCook909
1999 - 2003 7.3L Power Stroke Diesel
22
May 26, 2011 03:03 PM
Studawg
1999 - 2003 7.3L Power Stroke Diesel
15
Mar 9, 2011 01:06 PM
StampedePSD
1999 - 2003 7.3L Power Stroke Diesel
42
Dec 28, 2008 05:29 PM
