Problem instaling amp power steps
Thread Starter
|
Freshman User
Joined: Feb 2010
Posts: 42
Likes: 0
From: Richmond
Problem instaling amp power steps
Hey all. Im instaling the amp power steps. Did it backwards so to speak. lol Meaning i went ahead and wired it all up and now doing the brackets. My problem is the one motor hits the rear frame brace on the drivers side and on the passenger side it hits the Ac lines. Got a sugestion of putting the motor on the front of the truck. Tried it and it still hits the Ac line. Thanks in advance for the help.
Elder User
Joined: Mar 2007
Posts: 514
Likes: 1
From: Tampa
When I installed my powersteps, I disconnected the bracket that holds the line and was able to move the line up, after that I was able to bend the AC line very gingerly. I was concerned but not too much, 6 months later, still no issue.
Thread Starter
|
Freshman User
Joined: Feb 2010
Posts: 42
Likes: 0
From: Richmond
Thanks BigRy. Thats what i ended up doing. It scary moving those lines. Did it yesterday and since you got six months of use with no problems. im not going to even worry about it. Thanks for the help
Thread
Thread Starter
Forum
Replies
Last Post
AC75
Explorer, Sport Trac, Mountaineer & Aviator
30
Dec 6, 2019 10:15 PM
