What Have YOU Done To Your Truck Today?
#9093
When I bought my truck I knew the rear drive shaft wasn’t the right one. It was out of a Int. Scout! Found a nice used take out of a ‘78 truck a local guy was stripping for parts. Put in new u joints and installed today. My slight vibration is gone (no surprise) and my worries of the Scout driveshaft coming apart at the slip joint is gone as well! Wooohooo!
#9099
Steering
Finally feeling well enough to get back into the steering parts.... New Shaft, rebuilt box, valve, cylinder, new lines... hope to run fluid tomorrow, didn't want to push my luck anymore tonight..
valve
cylinder and new lines
borgeson shaft and rebuilt box
rebuilt blue top box and shaft connect
valve
cylinder and new lines
borgeson shaft and rebuilt box
rebuilt blue top box and shaft connect
#9101
#9102
https://www.ford-trucks.com/forums/1...tallation.html
#9104
I don't know if the shields are factory or not. This truck has an odd mixture of new parts in unexpected places so far. And yes, working on a new cam due to collapsed lifter. But I may have to pull the engine to replace the bearings first. Trying to weasel my way out of it, but I think I know my answer...
https://www.ford-trucks.com/forums/1...tallation.html
https://www.ford-trucks.com/forums/1...tallation.html
#9105
Finally feeling well enough to get back into the steering parts.... New Shaft, rebuilt box, valve, cylinder, new lines... hope to run fluid tomorrow, didn't want to push my luck anymore tonight..
valve
cylinder and new lines
borgeson shaft and rebuilt box
rebuilt blue top box and shaft connect
valve
cylinder and new lines
borgeson shaft and rebuilt box
rebuilt blue top box and shaft connect