Transfer case swap/upgrade
Thread Starter
|
Posting Guru
Joined: Dec 2008
Posts: 1,226
Likes: 5
From: Rusty, Maine
Transfer case swap/upgrade
Finally upgraded my Borg Warner 13-56 to a BW 44-07. Have pics just to show how much beefier it's is.
http://i736.photobucket.com/albums/x...1260594158.jpg
44-07 on the left and 13-56 on the right...... In case you couldn't tell.
http://i736.photobucket.com/albums/x...1260594189.jpg
a closer pic of the 44-07
http://i736.photobucket.com/albums/x...1260594158.jpg
44-07 on the left and 13-56 on the right...... In case you couldn't tell.
http://i736.photobucket.com/albums/x...1260594189.jpg
a closer pic of the 44-07
Senior User
Joined: Mar 2009
Posts: 180
Likes: 0
From: Las Vegas
There has been a bit of discussion about the 4407 lately, and I'm still a bit confused. As your pics show, it sure appears to be a big, beefy unit, but I think some guys don't like it. I'm not sure why this is??? My truck has one, and I'm wondering about any issue/problems with them. Sure looks like a good piece to me, though. How did the swap go?
Thread Starter
|
Posting Guru
Joined: Dec 2008
Posts: 1,226
Likes: 5
From: Rusty, Maine
I swaped out great the only trouble I had (besides the 44-07 feeling like is twice as heavy as the 13-56) was the rear output flange on the 44-07 doesn't except the slip yolk so I had to have the slip drive shaft out of the parts truck shortend. Everything else was a breeze.
Thread
Thread Starter
Forum
Replies
Last Post
eriklane
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
7
Sep 11, 2013 09:13 PM
460
Clutch, Transmission, Differential, Axle & Transfer Case
15
Jan 5, 2007 08:49 PM
