Flat Bed Designs
Post Fiend
Joined: Jun 2002
Posts: 13,873
Likes: 3
From: Atlanta GA
When I put a flatbed on, I like to run square stock for a bumper, attach a pintle hook to that (off set it) , put a receiver tube attached to the bumper in the middle, and make arrangements for a winch somewhere in the bed. Helps pull out out backwards and helps pull stuff into the bed.
Headache rack is a must and I like to put a sheet of 12 gauge over a framework of metal, with a covering of 2x12 PT wood inside the bed. Reason being is it keeps the metal from denting and will stop a stray hook or frozen block of sand from coming through the cab. I like to keep the tire up front and fuel cans in the back.
Headache rack is a must and I like to put a sheet of 12 gauge over a framework of metal, with a covering of 2x12 PT wood inside the bed. Reason being is it keeps the metal from denting and will stop a stray hook or frozen block of sand from coming through the cab. I like to keep the tire up front and fuel cans in the back.
Thread
Thread Starter
Forum
Replies
Last Post
MVAgusta
2017 - 2022 Super Duty
5
Apr 18, 2017 12:38 PM
Trucker 1973
1947 and Older Ford Trucks
12
Dec 1, 2012 11:13 PM
