Is is a cause for concern
Thread Starter
|
Mountain Pass
Joined: Mar 2004
Posts: 127
Likes: 0
Is is a cause for concern
I was using a big hammer to knock the ower ball joint stud out of the knuckle and accidentally hit the outer tie rod end and pinched a small hole in its rubber boot (I had just finished putting that tie rod in ten minutes before). A very thin stream of grease came out of the boot. Is this going to give me problems down the road? Can the boots be replaced?
Thread
Thread Starter
Forum
Replies
Last Post
bigcrunch
1973 - 1979 F-100 & Larger F-Series Trucks
1
Nov 1, 2014 01:39 PM
madpogue
1994.5 - 1997 7.3L Power Stroke Diesel
4
Apr 4, 2012 02:06 PM
anotherfordguy
1999 - 2003 7.3L Power Stroke Diesel
4
Dec 11, 2006 09:26 AM
