found this on ebay
http://cgi.ebay.com/ebaymotors/f250-...em170196686287

 

thats a deal right? what is the hard to find pipe for intercooling one?

 

ah, not in there but it is available from ford again, its the early 99 x pipe

 

this is an odd one
http://cgi.ebay.com/ebaymotors/1994-...em330215121023

 

Looks like it would work. There's not many option anymore since Ford stop making the early 99 spyders.

 

how much is the spider from Ford? any idea?

 

they have been re-released again, i dont know the current price but the old ones retailed for about 120 bucks

 

so, with that price in mind, if you got an intercooler offa junk truck what would cost be, and labor hours with properly furnished garage to intercool one?

 

i put mine together in a saturday. you can get coolers off ebay cheap, 100 bucks give or take a few bucks. the tubes are available online too, i used a combination of 6.0 and 7.3 tubes to get my bends the way i wanted them and used the rubber connections to hold it all together.

 

oh and my tools were all basic hand tools, hack saw, and tape measure. no lift required or jacks, didnt even remove my bumper, just the headlight support.

 

so tubes and cooler from e-bay, spider from Ford? sounds like maybe get it all togather for under $400 right?

 

sounds about right, maybee cheaper if the shopping goes well

 

here are stock pipes, i think if you use a 7.3 intercooler all you have to do is add a small length to the one side.
http://cgi.ebay.com/ebaymotors/99-03...spagenameZWDVW

here is the whole kit
http://cgi.ebay.com/ebaymotors/2004-...spagenameZWDVW

 

looks good c00n. is that kit in the last pic everythng that would be needed?

 

I did mine for $240. Only wish I had done the 6.0 cooler rather than the 7.3 cooler.