Chip trucks 2nd paint job. This time by me in the driveway.





Learn how here, guys:

How to: Driveway Base Coat, Clear Coat Paint Job - Prep to Buff

 

 

My 1996 F150

 

That is a sweet ride. What percent tint is on the windows?

 

I'm not sure. I bought it with that tint on it, but it isn't legal for SC. I figure I will just redo it if I ever get pulled over.

 

I am guessing it is 5%. Is the front tinted?

 

No. Just the sides and the back.

 

‘91 f250

 

 

Man, this takes me back. My dad had one like this, but silver where this one is white when I was a kid. Those seats make the think about the many miles we put on that truck!

 

1992 F250, low mileage diesel

 

This might be a good place to ask seeing as all your trucks are within the generation of the parts truck I'm using for my 56 Mercury M350.
This shift lever needs to have a bend put in it so it doesn't interfere with the steering wheel and I'm not sure how much of it is solid stock.


I'm thinking it's only the top narrowed section on top where the k n o b is pressed on that is solid.
I'm afraid of heating it up and attempting to make the bend and end up kinking the tube. Finding another lever around here might prove difficult..

 

Car-Part.com is an option. It's a salvage yard website.

 

He's in Canada.

That's a 5 speed out of a 96 150

 

What trans are you to use? As I recall ZF and the Mazda used same shifter. I have a spare you can have if needed for an experiment

Yes, only up top is solid, bottom bonded

One could always pick up an aftermarket lever, Core sell them and some new place that also makes ZF short shifters