Injectors

Reply Subscribe

Thread Tools

Search this Thread

Sep 20, 2007 | 10:16 AM

eprn1n2

Thread Starter

Senior User

Joined: Sep 2007

Posts: 159

Likes: 0

From: Fort Collins

Injectors

I'm going to remove and send in the injectors to get cleaned. Any tips on removing them from a 1990 5.8L EFI?

Sep 20, 2007 | 10:56 AM

rbloodhound

FTE Chapter Leader

Joined: Mar 2007

Posts: 4,911

Likes: 7

From: Crowville Louisiana

Pull the fuel rails and pull the injectors out with a twisting motion. The only thing holding them is an oring seal. Where are you going to send them for cleaning?

Sep 20, 2007 | 11:00 AM

eprn1n2

Thread Starter

Senior User

Joined: Sep 2007

Posts: 159

Likes: 0

From: Fort Collins

Thanks for the info. Are the fuel rails straight forward? I'm going to send them here.

http://www.witchhunter.com/

Sep 20, 2007 | 01:01 PM

rbloodhound

FTE Chapter Leader

Joined: Mar 2007

Posts: 4,911

Likes: 7

From: Crowville Louisiana

For not much more $ than that you can get a set of injectors from sumitt racing or jeggs. What if you send them in and they find several bad. For the money I would replace them. Just something to think about.

Sep 20, 2007 | 04:20 PM

EPNCSU2006

Lead Driver

Joined: Nov 2002

Posts: 9,557

Likes: 44

From: Concord, NC

Witchhunter does some good work. I've sent some motorcycle injectors in for cleaning and you get a chart with the before and after flow rates. It's quite a bit cheaper than buying new injectors.