just installed B-Quiet
Elder User
Joined: Dec 2002
Posts: 793
Likes: 0
From: SoFla
What's the install protocol. Is it best to work from front to back? I will apply the B-quiet to floor, wheel wells, side walls and if enough headliner. I also have 25sqf VComp. Not sure where to install the VComp? wheel wells? Looking to VComp and Ultimate together in some places of the truck Where would I get the best results using the combination of the two materials?
I will use denatured alcohol and vac.
I will use denatured alcohol and vac.
Post Fiend
Joined: Mar 2007
Posts: 26,966
Likes: 50
From: Texas
I went back to front on mine, but it really doesn't matter. I saved the inside of the doors for last in case I ran out of time or material. When I was researching this the consensus seemed to be the v-comp type material did the best on the back wall, inside the doors, and on the firewall. I didn't pull my dash so I didn't get very far up the sidewall.
Don't know if that's the best way to use it, but that's the way I remember reading it.
Don't know if that's the best way to use it, but that's the way I remember reading it.
Thread
Thread Starter
Forum
Replies
Last Post
Greywolf
General NON-Automotive Conversation
148
Mar 21, 2008 12:28 PM
PowerstrokeJunkie
1999 - 2016 Super Duty
39
Sep 22, 2007 12:39 PM
weldman
Audio & Video Systems, Navigation, Satellite Radio & Mobile Electronics
2
Nov 29, 2001 08:06 PM
