using old style ignition switch :-
Thread Starter
|
New User
Joined: Jun 2006
Posts: 9
Likes: 0
From: omaha, ne
using old style ignition switch :-
http://www.ctci.org/membership/Gilsgarage/IgSwWi.htm I'm using a old style ignition switch in my 86 grumman kurbmaster van. I have bypassed the colum ignition switch and have wired in a 1985 ignition system on my 1986 300 I-6 and I'm in the process of wiring the van from under the hood and dash from scratch. The problem I'm having is that when I start the van the starter keeps ingaged and only when I turn the key to the start postion. As soon as I turn off it disingages, This doesn't happen when I turn the key to the on postion. Will this ignition switch work with this ignition system? And what placement of the wirers to the switch is needed? The web link just shows what style of switch I'm using.
Moderator
Joined: Jan 2001
Posts: 56,992
Likes: 2,741
From: Virginia
You can't tie some of the hot wires together on one switch terminal. You need a multipole switch like the original one was or you will get feedback from different circuits, although usually this causes the engine not to turn off. You could try putting the starter on a seperate pushbutton. You should only need the red/blue wire hooked to the pushbutton.
Is there are reason why you are trying to do this?
Is there are reason why you are trying to do this?
Thread Starter
|
New User
Joined: Jun 2006
Posts: 9
Likes: 0
From: omaha, ne
The wiring in the van was a rats nest of where it was cut into so many times that it was a fire hazard. And best to start off wiring it new. I strip all wires from under hood and dash.
Thread
Thread Starter
Forum
Replies
Last Post
Action410
1987 - 1996 F150 & Larger F-Series Trucks
6
Jan 18, 2013 07:40 PM
ryaneverk2
1999 - 2016 Super Duty
25
Feb 17, 2006 03:45 PM
masonmachines
1987 - 1996 F150 & Larger F-Series Trucks
5
Jun 15, 2004 09:37 PM
