excursion stuck in 4x4 low range
Thread Starter
|
Freshman User
Joined: Feb 2007
Posts: 27
Likes: 0
excursion stuck in 4x4 low range
ok well i turned my **** to 4x4 low cuz my tires were spinning while backing up a trailer. Now the truck is stuck in it. 4x4 and low range are lit up on my gauge cluster. i tried turning the **** and it will not do anything. any help is needed asap becuz i need to trailer again tomorrow
Senior User
Joined: May 2007
Posts: 197
Likes: 0
From: coarsegold, ca
just did this, put in neutral, twist ****, then put back in gear. if it dont work you can shift it manuely from uderneth the vehicle, there will be a deep hole for a 1/2 drive extension to fit and twist it to go in any range of the case. good luck.
it's all in there. 
Elder User
Joined: Aug 2006
Posts: 909
Likes: 0
check your manual. I may be wrong, but I thought it said something about driving a little bit in reverse to allow the gears to get a situated and stuff. Its worth a try... maybe it'll help them mesh...
Hey, if that doesn't work, just put some realy humongously large tires on it. That way, for each rev the engine makes, it will push the car further...
Good luck
Isaac
Hey, if that doesn't work, just put some realy humongously large tires on it. That way, for each rev the engine makes, it will push the car further...
Good luck
Isaac
Thread
Thread Starter
Forum
Replies
Last Post
