C-bushing identification
Thread Starter
|
Elder User
Joined: Oct 2003
Posts: 598
Likes: 0
From: Harrisburg, SD
C-bushing identification
Getting ready to do my front axle swap, I have a 5.5 lift that the previous owner had installed. I see that it has new C bushings but I dont think they are enough degree because the angles on the shaft seem a bit much. is there a marking or way of identifying what degree the bushings I have now are? I looked all around the outside and didnt see much...
Lead Driver
Joined: May 2000
Posts: 9,236
Likes: 12
From: Senoia, GA
yea if you take the bushings off they are on the inside. if they have been run long enough you may not be able to read the raised lettering
aside from that, i dunno aside from comparing to other degreed bushings
-cutts-
aside from that, i dunno aside from comparing to other degreed bushings
-cutts-
Thread
Thread Starter
Forum
Replies
Last Post
