97 Ford Ranger
Thread Starter
|
New User
Joined: Oct 2006
Posts: 3
Likes: 0
97 Ford Ranger
I am working on a 97 Ford ranger. All of a sudden the wipers quit working, I have replaced the motor, the switch, the relay and checked all of the fuses and all wires for being cut or burnt, everything is looking good. Yet I still have no wipers. I have looked at the Haynes manual and it shows no wiring schematics for the wiper system and no info on any voltage readings for any of the wires goin into the motor. The windshield washer motor is pumping fine but the wiper motor wont turn on when I depress the washer button. Any help would be greatly appreciated.
Junior User
Joined: Sep 2006
Posts: 50
Likes: 0
My 94 did that a while ago... Turns out it was the ground from the wiper motor to the body... I could hear the clicking of the motor controller but the wipers didn't move...
Cleaned the ground, everything worked fine after... Hope this helps...
Cleaned the ground, everything worked fine after... Hope this helps...
Thread Starter
|
New User
Joined: Oct 2006
Posts: 3
Likes: 0
Im getting 5.8 volts to the #3 and #5 pins and nothing to any of the others. The motor is the 6 pin motor and not the 5 pin. Im getting 12 volts in to the wiper switch on two different pins.
Last edited by gunner5176; Oct 21, 2006 at 12:21 AM.
Thread Starter
|
New User
Joined: Oct 2006
Posts: 3
Likes: 0
I was wrong im only getting around 5.8 volts to the light blue and solid white wires on the motor connector. those wires are the #2 and #5 pins on the connector, all the grounds are reading 12.35 volts, which is what the battery is putting out.
Thread
Thread Starter
Forum
Replies
Last Post
okie#1
1973 - 1979 F-100 & Larger F-Series Trucks
16
May 9, 2020 02:10 AM
eclectix
1967 - 1972 F-100 & Larger F-Series Trucks
19
Aug 18, 2003 12:50 AM
